Current offer
-15% on all spare parts
Shop parts →
Spare parts only. Cannot be combined with other offers.

Delivery in 3–10 business days · 2-year warranty on 79Bike & Y-VOLT · Secure payment

Carbon parts for Sur-Ron & 79Bike
Genuine carbon

Carbon parts for Sur-Ron & 79Bike

31 carbon fibre parts — lighter, stiffer, premium finish for Light Bee X, Ultra Bee and 79Bike Falcon Pro / GT.

Weight saving

Up to 60% lighter than stock plastic, a direct cut in unsprung mass.

Stiffness

High-density 3K/12K weave, heat-stable epoxy resin.

Race look

Gloss or matte finish, fits Falcon Pro / GT (Sur-Ron chassis).

31 / 31 carbon parts

Looking for a specific carbon part?

Fenders, covers, number plates, guards: contact us to confirm availability and fitment.

Request a carbon quote

Sur-Ron & 79Bike maintenance guide

Electric off-road bikes need far less servicing than a combustion machine — no oil, no filters, no spark plug — but the chain, brakes, suspension and battery still wear. Here is the routine our workshop applies to every Sur-Ron & 79Bike we service, and the parts you need for each job. Always follow the intervals in your owner's manual: they take priority over any general guidance.

Service schedule

Before every rideTyre pressure, brake lever feel, chain tension, wheel nuts, battery charge and connector condition.
After every muddy or wet rideRinse without high pressure on bearings/connectors, dry, then re-lube the chain.
Every 10 riding hoursChain and sprocket wear, brake pad thickness, spoke tension, bolt torque check on the swingarm and controller mounts.
Every 30 riding hoursBrake fluid condition, fork oil inspection, wheel and steering bearings, motor pinion and belt/chain replacement if hooked.
Seasonally / storageStore the battery around 50–60% charge in a dry place, recharge every few weeks, clean and protect contacts.

Core jobs, step by step

  1. 1.Chain and sprockets

    Clean with a degreaser, brush both sides, dry, then lube the inner side of the chain while turning the wheel. Adjust tension to the manual's slack figure. Replace the chain and both sprockets together once the teeth are hooked.

    Chains, front pinions, rear sprockets, chain lube

  2. 2.Brakes

    Measure pad thickness and replace once roughly 1 mm of friction material is left — below that the backing plate bites into the disc. Check the minimum thickness figure stamped on the disc itself (typically about 1.5 mm under the original thickness, disc-dependent) and never ride below it. Most electric off-road bikes use DOT4 fluid, but confirm on the master-cylinder reservoir cap; brake fluid is hygroscopic, so it absorbs moisture over time and its boiling point drops — bleed and replace it every 2 years even with no sign of fade. Bleed sooner if the lever feels spongy, and inspect the disc for scoring or warping. Bed new pads in with around ten progressive stops without locking the wheel before braking hard.

    Pads, discs, calipers, brake fluid, hoses

  3. 3.Suspension

    Wipe the stanchions after every ride, check for oil weeping at the seals, and service fork oil once travel feels harsh or noisy. Set sag for your weight before chasing damping settings.

    Fork seals, springs, rear shocks

  4. 4.Battery and electrics

    Charge with the supplied charger, avoid leaving the pack fully empty, and keep connectors clean and dry. Inspect the main harness and controller connectors for corrosion or heat marks at every service.

    Chargers, connectors, BMS, controllers

  5. 5.Wheels and tyres

    Check pressure cold before every ride: off-road tyres usually run between 1.0 and 1.7 bar (15–25 PSI) depending on terrain — lower on soft or muddy ground for grip, higher on hard-pack or tarmac to avoid pinching the inner tube. Always follow the manufacturer's figures for your model. For road-legal use in Europe the legal minimum tread depth is 1.6 mm, though knobs usually need replacing well before that for real grip. On spoked wheels, re-check spoke tension after the first 50 km (spokes bed in and slacken slightly), then at every service. Most electric off-road bikes in this segment still run inner tubes rather than tubeless, so check carefully for a pinched tube when fitting. Supermoto wheelsets swap the bike from trail to street use.

    Tyres, inner tubes, wheelsets, bearings

Not sure which part fits? Send us your VIN or a photo and our team confirms fitment before shipping. Free pickup at our stores in Saint-Gaudens, Barcelona and Vielha, and workshop fitting by appointment.

Talk to the workshop

Frequently asked questions

Are Surron & 79Bike parts compatible with my bike?+

We only stock parts referenced for Surron & 79Bike. If in doubt, send our support team your VIN or a photo — we confirm fitment before shipping.

Do you ship across Europe?+

Yes, we ship to the whole EU (France, Belgium, Spain, Portugal, Italy, Germany, etc.) with tracked delivery.

Can I collect my order in-store?+

Yes — free pickup at our workshop-store in Le Cuing, near Saint-Gaudens (31, France). Select the option at Shopify checkout.

Do you offer workshop / installation service?+

Yes, our workshop installs parts by appointment in Saint-Gaudens and Barcelona. Contact us for a workshop quote.